Lab 6: Solid Evidence Lab



Solid Evidence Lab

Introduction:

The purpose of this lab was to observe the chemical reactions when you combine two polyatomic compounds. Also, it was to allow us observe double replacement reactions which resulted with either no reaction or an aqueous solution and a precipitate (solid). 



 
























Conclusion:

In the end, our lab was very successful because we were able to complete it very quickly with clear results. I was pretty surprised with with how quick the reactions really were because they were over in a matter of seconds. The biggest challenge of this lab was trying to identify exactly what had reacted because sometimes it appears cloudy like a reaction had taken place but never really did. However, we were able to look closely and see what really happened so everything worked out okay. 
Also, the lab was good because it gave us examples for writing molecular and net ionic equations.


Comments

Post a Comment

Popular posts from this blog

Lab 18: Alka Seltzer and the Ideal Gas Law Lab

Image
Alka Seltzer and the Ideal Gas Law Lab Introduction: The purpose of this lab was to determine the mass of carbon dioxide released when a sample of alka seltzer is placed in water. This was done by collecting the gas in a balloon and measuring its dimensions after the reaction. This would allow us to get an estimate of about how much volume of gas was in the balloon and determine the amount of CO2 given off. We could determine the volume not only by measuring the size of the balloon but also filling the balloon to the same size with water and measuring the amount of water in a graduated cylinder.            (Balloon before alka seltzer put in water )          (Balloon after alka seltzer put in water) Data: Calculations: Analysis Questions: 1.    Discuss an area in this lab where expe r imental error may have occurred. One of the main spots we could have had an experiment al error was when we attempted to fill the balloon with water to the same size i
Read more

Lab 4: Atomic Mass of Candium Lab

Image
Atomic Mass of Candium Lab Introduction: The purpose of this lab was to use a new element called Candium and calculate its average atomic mass. We were given several different quantities "Candium" atoms which represented different isotopes, and a scale. The important terms for this lab was isotope, percent abundance, and average atomic mass. An isotope is the different variations of the same atom just with different number of neutrons or different atomic masses. Percent abundance is the amount of an isotope that is present in the world in comparison to other isotopes, so basically how common the isotope is found. Average atomic mass is the sum of each type of isotope multiplied by its decimal abundance all divided by 100. Data: Our average atomic mass of Candium was 0.955 grams (0.71842)x(0.8376g) + (0.22407)x(0.985g) + (0.05809)x(2.29g) = 0.995g        ↑                                    ↑                                 ↑ (Decimal abundance o
Read more

Lab 11: Flame Test Lab

Image
Flame Test Lab Introduction/Pre-Lab: The purpose of this lab was to observe the effect of certain compounds and more specifically elements in the compounds being burned. Basically, this means trying to find patterns of the flame color when different elements are burned. This was done by putting several known solutions on different wooden splints and putting them over a fire to see the change in color. Then, to test our ability of identifying the compound, we were given two unknown solutions and by observing the flame color when burned, we attempted to predict what compound it really was. 1.    What is the difference between ground state and an excited state? The difference between ground state and excited state is the energy levels. When an element's electrons are at their lowest energy levels available, it is known as the ground state. When an element's electrons absorb some form of energy, their energy levels raise causing the element to be at its excited state w
Read more